Husqvarna Rider 18 ProFlex Workshop Manual page 34

Reparation instructions
4
Rider 18 ProFlex
Disconnect the contact (1) and take off the hose
(2). Ensure that the oil does not run out, e.g. tie up
the hose higher than the oil level in the container.
5
Rider 20 ProFlex
Disconnect the wire from the differential lock by
undoing the tensioning nuts (on upper bracket) and
freeing the wire from the differential arm.
32
– English
6
Insert a garage jack under the hydrostatic transmis-
sion and loosen its five holder screws.
On the Rider 20 the rear mounting screw is at the
rear of the frame.
7
• Lower the garage jack and pull out the
hydrostatic transmission.
• Installation of the hydrostatic transmission is
carried out in the reverse hydrostatic transmis-
sion removing order
• After installation, check that the brake wire and
hydrostatic transmission wire are correctly
adjusted (see "Checking and adjusting brake
wire" and (Checking and adjusting speed
control"). Also check the oil level in the
hydrostatic transmission and refill as necessary.
On the Rider 20 ProFlex you should also check
and adjust the wire for the differential lock, see
"Checking and adjusting differential lock".