Husqvarna Rider 18 ProFlex Workshop Manual page 11

Maintenance
Lubricate throttle control
Lubricate choke control
Smörj styrkedja i ramtunnel.
Lubricate steering chain inside frame
tunnel
Clean engine cooling air intake
Clean pre-filter or oil-foam element,
if fitted
Clean air filter cartridge
Change engine oil 1)
Check/adjust cutting height setting
Check/adjust parking brake
Inspect flame guard/spark arrestor
(optional equipment)
Replace engine oil filter
Clean/replace spark plugs
Replace fuel filter in pipe
Clean pulse-air filter
Clean cooling system
Check engine valve clearance
Check whether oil change
change 4) are necessary for K66 gearbox
(every 500 hrs)
Replace air filter (pre-filter)
Replace air filter (paper filter)
Carry out 300 hour service
1) 2)
First change after 5 hours.
every 25 hours if pre-filter is not fitted. Clean and replace the filter more often in dusty conditions.
lubrication should be conducted twice a week.
= Covered by this workshop manual.
= Not covered by this workshop manual.
!
WARNING!
No service procedures must be conducted on the engine or cutting unit unless:
• The engine is switched off.
• The ignition key is removed.
• The ignition cables are removed
from the plugs.
Page
-
-
-
-
-
-
2)
-
21
47
24
-
-
-
-
55
-
4)
-
4)
or filter
-
2)
-
2)
-
4) -
When driving with a heavy load or when the ambient temperature is high, replace every 25 hours. Clean
4)
Conducted by authorised service workshop.
Daily main-
Weekly 3)
tenance
main-
before after
tenance
• The parking brake is applied.
• The cutting unit is disengaged.
Maintenance schedule
Maintenance interval in
At least
hours
once a
year
25 50
3)
For daily use of the machine
100 300
9
English –