2
Position the pulley with tool no. 506 79 06-01 and
tighten it with moment (80 Nm). Use tool no. 506 89
92-01 as a holder-on.
3
Position the wires in the wire holder, clamp the
holder together and, from below, lead it up through
the centre of the belt tensioner until it hooks over
the tensioner's upper edge.
4
Attach the throttle and choke wires to the
carburettor and position the wire clamps without
tightening them.
5
Set the throttle control to full throttle and the choke
control to full choke. Pull the wires' outer cover as
far as possible to the right and tighten the clamp
screws.
6
Attach the silencer and exhaust pipe and tighten
the holder screws and pipe clamps.
Reparation instructions
19
English –