Removal Of Belt; Assembling The Belt - Husqvarna Rider 18 ProFlex Workshop Manual

Reparation instructions
Removing the belt
Starting point when dismantling the belt:
• No unit attached to the Rider.
• The front of the belt is hung around the hook
guard's handle.
For a description of how to prise the front part of the
belt off the front pulley see steps 2–3 under "Remo-
ving the cutting unit".
The entire belt is only dismantled as set out below,
when the snow plough is fitted on the Rider.
1
Dismantle the steering plate under the support
wheel. Use two 13 mm socket spanners.
2
Unhook the spring on the blade brake. Pry off the
belt from the intermediate pulley and remove the
belt.
46
– English

Assembling the belt

1
• Position the belt from the front and let the front
end of the belt hang around the hook guard's
handle.
• Fit the belt on the intermediate pulley and
against the support wheel.
2
• Fit the steering plate under the support wheel
and tighten the bolts using two 13 mm socket
spanners.
• Lay the belt in position over the drive pulley and
tensioning pulley. Attach the belt tensioning
spring.
3
Hook on the spring for the blade brake.