Panasonic CF-W2 Series Reference Manual page 145

Dealing with Problems (Advanced)
Disk Operations
Unable to read/write to the hard disk
Trouble has occurred with the disk
The DVD-ROM & CD-R/RW drive
status indicator does not light
Cannot play disk or read data from it
Cannot play back TV programs
recorded on a commercial DVD
recorder
Cannot play music CD or DVD-Video
automatically after setting it in the
drive
A blue background appears on the
screen with the MPEG image or DVD
Video
If the DVD-ROM & CD-R/RW drive
vibrates excessively or is noisy
Cannot eject disk
Your drive or file may not have been properly set
Check to see if the hard disk is full. If it is full, delete unnecessary files
Your hard disk content may be corrupted. Contact your technical support office
You may need to clean the lens or disk.
• Cleaning the lens ( page
• Cleaning the disk ( page
Is the disk set correctly?
Is the disk bent, scratched, or dirty?
In the following cases, finalize the recording on the DVD recorder:
• When the program was recorded in DVD-R/RW in video mode
• When the program was recorded in DVD-RW in VR mode
Remove the disk and reinsert it. If the problem persists, run the applicable
software and play
Did you open the DVD-ROM & CD-R/RW drive or remove the disk while it was
operating?
Re-insert the disk and close the disk cover
Is the disk bent or labeled?
Check to see if the disk is inserted correctly, and is in good condition. If the disk
is good and inserted correctly, set [CD/DVD Drive Speed] to [Low] in the Setup
Utility. ( page 120)
When writing to a disk using B's Recorder, you can minimize vibration while
writing by setting the writing speed at [8x] or less
Is the computer powered on?
Open lever works only when the computer's power is on.
To remove a disk when the computer is powered off, insert a pointed object
(e.g., the bent-out tip of a paper clip, or the tip of a pencil or ballpoint pen) into
the emergency hole, and then move (
56)
64)
page 55)
145