Panasonic CF-W2 Series Reference Manual page 136

Dealing with Problems (Advanced)
Standby/Hibernation Function
Unable to automatically enter standby
or hibernation mode
The computer does not resume
Battery Indicator
The red indicator lights
The red indicator blinks
The orange indicator blinks
Keyboard
Only numbers can be input
Only capital letters are being input
If a peripheral is connected to the computer, disconnect the device
If there is a disk in the DVD-ROM & CD-R/RW drive that has been formatted
using B's CLiP, the computer will not enter standby or hibernation mode.
Remove the disk
When the internal LCD is closed, the computer may not enter standby or
hibernation mode. In order to activate standby or hibernation automatically
while using the computer with the internal LCD closed, set [Touch Pad] to
[Disable] in the [Main] menu of the Setup Utility
Did you disconnect the AC adaptor or the battery pack while the computer was
in standby mode? If the computer's power supply is disconnected while the
computer is in standby mode all unsaved data will be lost
Did you slide the power switch and hold it for four seconds or more? If so, the
power will be turned off forcibly. In this case, all unsaved data will be lost
The battery level is very low (the charge is approx. 9% or less).
Connect the AC adaptor. You can use the computer when the battery indicator
light is orange. If you do not have an AC adaptor, save your data and power off
your computer. After replacing the battery pack with a fully charged one, turn
your computer on again
Quickly save your data and power off your computer. Remove the battery pack
and disconnect the AC adaptor, then connect them again. If the problem
persists, contact your technical support office. The battery pack or charging
circuit may be defective
Battery cannot be recharged temporarily because the internal temperature of
the battery pack is outside the acceptable temperature range for recharging.
Once the range requirement is satisfied, charging begins automatically. Your
computer can be used normally in this state
Check whether the indicator
mode. To disable the ten-key mode, press the NumLk key (
Check whether the indicator
mode. To disable the Caps Lock mode, press the Caps Lock key (
is on. If it is on, the computer is in ten-key
is on. If it is on, the computer is in Caps Lock
136
page 23)
page 22)