Panasonic CF-Y2 Series Reference Manual page 96

Writing to CDs/DVDs (B's Recorder/B's CLiP)
After formatting the disk, if the disk does not mount (is not recognized), remove it, and
insert it again.
Eject the formatted disks as described below.
When ejecting the disk while the
fication area
Right-click the icon and click [Eject].
Only eject disks as described above.
If you cannot eject the disk even after attempting the operation described above, shut
down Windows. After the power is off, insert a pointed object (e.g., the bent-out tip of a
paper clip, or the tip of a ballpoint pen) into the emergency hole (A) and move it in the
direction of the arrow.
To disable B's CLiP when it is not used
Make the settings following the steps below
A Log-on to Windows with the administrator authority.
B
Click [start] - [All Programs] - [B.H.A] - [B's CLiP] - [B's Config].
C Add a check mark for [Disable B's CLiP] at [System configuration], and click
[OK].
D
When a message appears asking if you want to restart your computer, click
[Yes].
• To start using B's CLiP again, remove the check mark from [Disable B's CLiP] using
step C described above, and click [OK].
When accidentally deleted B's Recorder or B's CLiP
If you uninstall the software accidentally, also re-install it following the steps below
A Log-on to Windows with the administrator authority.
B Set the Product Recovery DVD-ROM in the DVD MULTI drive.
C Click [start] - [Run] and input [d:\bha\setup.exe]
Follow the onscreen instructions.
• When the message that requires the serial number appears during the installation, input
the serial number that is located under "Dealing with Problems (Summary)" /
"Reinstalling B's Recorder/B's CLiP" in the Operating Instructions
96
icon is displayed on the noti-
*1
, then click [OK].