Standby (Q&A) - Panasonic CF-Y2 Series Reference Manual

Dealing with Problems (Advanced)
Standby/Hibernation Function
Unable to enter standby or hibernation
mode
Unable to automatically enter standby
or hibernation mode
The computer does not resume
Takes time to resume
Battery Indicator
The red indicator lights
If a USB device is connected to the computer, the standby or hibernation
function may not work properly. In this case, remove the USB device if Windows
does not work properly. If the problem persists, restart the computer
It may take a minute or two to enter standby or hibernation mode
If there is a disk in the DVD MULTI drive that has been formatted using B's CLiP,
the computer will not enter standby or hibernation mode. Remove the disk
The computer may not enter standby mode properly and seems to be frozen in
the mode that the computer is communicating via the modem. When you
cannot execute operations, slide the power switch for four seconds or more to
forcibly turn your computer off
If a peripheral is connected to the computer, disconnect the device
When the internal LCD is closed, the computer may not enter standby or
hibernation mode. In order to activate standby or hibernation automatically
while using the computer with the internal LCD closed, set [Touch Pad] to
[Disable] in the [Main] menu of the Setup Utility
If there is a disk in the DVD MULTI drive that has been formatted using B's CLiP,
the computer will not enter standby or hibernation mode. Remove the disk
Did you disconnect the AC adaptor or the battery pack while the computer was
in standby mode? If the computer's power supply is disconnected while the
computer is in standby mode all unsaved data will be lost
Did you slide the power switch and hold it for four seconds or more? If so, the
power will be turned off forcibly. In this case, all unsaved data will be lost
If the [CD/DVD Drive Power] is set to [Off] in the [Main] menu of the Setup
Utility, it may take about 20 seconds to resume from hibernation mode while a
disk is set in the DVD MULTI drive. Wait for a moment.
The battery level is very low (the charge is approx. 9% or less).
Connect the AC adaptor. You can use the computer when the battery indicator
light is orange. If you do not have an AC adaptor, save your data and power off
your computer. After replacing the battery pack with a fully charged one, turn
your computer on again
170