Panasonic CF-Y2 Series Reference Manual page 171

Dealing with Problems (Advanced)
Battery Indicator
The red indicator blinks
The orange indicator blinks
Keyboard
Only numbers can be input
Only capital letters are being input
How to input European characters (ß,
à, ç etc.), symbols or Euro currency
symbol is unclear
Networking: General
Unable to connect to a network
Quickly save your data and power off your computer. Remove the battery pack
and disconnect the AC adaptor, then connect them again. If the problem
persists, contact your technical support office. The battery pack or charging
circuit may be defective
Battery cannot be recharged temporarily because the internal temperature of
the battery pack is outside the acceptable temperature range for recharging.
Once the range requirement is satisfied, charging begins automatically. Your
computer can be used normally in this state
Check whether the indicator
mode. To disable the ten-key mode, press the NumLk key (
Check whether the indicator
mode. To disable the Caps Lock mode, press the Caps Lock key (
25)
Display the character map and point to the desired font name, such as
European fonts, and select it with the following procedure.
Click [start] - [All Programs] - [Accessories] - [System Tools] - [Character Map]
Confirm that either [Modem], [LAN] or [Wireless LAN] is set to [Enable] in the
Setup Utility ( page 153)
When using the computer as a network computer, some additional settings may
have to be made depending on the usage conditions. We recommend asking
your system administrator or the person in charge of the network
If the standby or hibernation mode is entered, the computer may have to be
restarted
If the link lamp on the HUB unit is not on and the network cannot be accessed,
set the speed to match the HUB unit (
is on. If it is on, the computer is in ten-key
is on. If it is on, the computer is in Caps Lock
page 135)
171
page 26)
page