Panasonic CF-Y2 Series Reference Manual page 134

LAN
Connecting LAN
There are specific settings required to set up LAN connection. Be sure to check system
administrator before attempting to your LAN.
When connecting multiple computers or peripheral devices in a home or office via a network,
printers or files can be shared among several computers.
CAUTION
Do not connect the modem telephone cable into the LAN port
To ensure proper network operations, use a twisted pair cable (category 5 or higher)
less than 100 m in length
In some cases, LAN cables with a cover attached to the connector cannot be
connected. Check this in advance
<Only for CF-W2 series>
Open the cover by hooking a finger on the small hollow near the bottom of the
computer
1
Power off your computer.
(⇒ Operating Instructions "Starting Up/Shutting Down")
Do not connect or disconnect devices while the computer is in standby or
hibernation mode.
2
Connect the cable.
Connect the LAN port (A) and the network system (server, HUB, etc.) using a LAN
cable.
3
Turn on the computer.
4
Set protocols, etc.
Check with your system administrator for these settings.
134