Index Of Abbreviations - Festo Smart cubic CPA-SC Series Manual

Contents and general instructions

Index of abbreviations

Term
Base block
Blanking plate
Components
CP
CPA−SC valve terminal
DI connection
FL connection
HC connection
Ident. code (I.C.)
Manual override
MP connection
PI connection
XII
The following product−specific terms and abbreviations are
used in this manual:
Meaning
Sub−base:
Base for sub−base valves and blanking plates
With connections for air supply (1, 12/14) and exhaust (3, 5, 82/84)
With work connections (2, 4)
With pressure compensation hole (L)
PRS block:
Base for semi−inline valve plates and blanking plates
With connections for air supply (1, 12/14) and exhaust (3, 5, 82/84)
Without work connections
With pressure compensation hole (L)
Plate without valve function, for reserving valve locations.
Common term for base block, valve plates and blanking plates
Compact Performance
Compact Performance sub−base Smart Cubic valve terminal (type 82) with
HC, PI, FL or MP connection.
CPA−SC valve terminal variant field bus direct DeviceNet"
CPA−SC valve terminal variant with 26−pin multipin plug strip for ribbon
cables as per DIN EN 60603−13. All valve solenoid coils are connected
centrally via this plug strip.
CPA−SC variant on which each valve plate has a horizontal connection.
Each valve is connected electrically with a special cable via this connection.
Identification Code. This is usually printed on the relevant component.
The component can be identified with this code (see Tab. 1/12).
Manual override
CPA−SC valve terminal with 25−pin multipin sub−D connection. All valve
solenoid coils are connected centrally via this connection.
CPA−SC variant on which each valve plate has a plug−in connection (vertical
connection). The relevant base block has a plug base for the electrical
linking of the valve solenoid coils.
Festo P.BE−CPASC−EN en 0412b