Safety During Maintenance; Switching-Off And Securing The Geared Drill; Use Of Lifting Equipments - Optimum Vario Select OptiDrill B 30VGM Operating Manual

WARNING!
Before activating the geared drill, double-check that

staff will not be endangered,

no damage is caused to equipment.
Avoid unsafe working practises:

Make sure your work does not endanger anyone.

The instructions in this manual must be observed during assembly, handling, maintenance
and repair.

Do not work on the geared drill if your concentration is reduced, for example, because you
are taking medication.

Observe the rules for preventing accidents issued by your association for the prevention of
occupational accidents and safety in the workplace or other inspection authorities.

Inform the inspector of any danger or failure.

Stay at the geared drill until all rotating parts have come to a halt.

Use prescribed protective equipment. Make sure to wear a well-fitting work suit and, where
necessary, a hairnet.

Do not use protective gloves during drilling work.
1.16

Safety during maintenance

Inform operators in good time of any repair and maintenance work.
Report all safety relevant changes or performances details of the geared drill. Document all
changes, have the operation manual changed accordingly and train the machine operators.

1.16.1 Switching-off and securing the geared drill

Turn the geared drill off using the main switch and secure the main switch and use a padlock to
prevent the switch from being turned on without authorization or by accident. Keep the key in a
safe place.
All machine components and hazardous voltages are disconnected. Only the points marked
with this pictogram are not included.
1.17

Use of lifting equipments

WARNING!
Use of unstable lifting and load-suspension gear that might break under load can cause
very serious injuries or even death.
Check the lifting and load-suspension gear on

sufficient load capacity,

perfect condition.
Observe the regulations for the prevention of accidents issued by your association for
the prevention of occupational accidents and safety in the workplace or other inspection
authorities.
Fasten the loads properly. Do not walk under lifted loads!
Safety
Version 1.0.3 dated July 22, 2014 Original operating instructions
OPTIMUM
M A S C H I N E N - G E R M A N Y
B30 VGM US
Page 15