Toshiba NV Series Hardware Manual page 15

This manual consists of the following chapters:
Chapter 1: Overview of T Series Migration
Describes the overview of T series migration and notes on migration.
Chapter 2: System Migration Procedures.
Describes the procedures to migrate from T2 series, S2E/S2T and T3* series
systems.
Chapter 3: Installation and Wiring
Describes the detail of installing and operating the system including installation
conditions, installation and wiring.
Chapter 4: Start and Stop
Describes how to start and stop the controller unit.
Chapter 5: Troubleshooting
Describes troubleshooting information such as measures to take when a failure or
error occurs.
Chapter 6: Maintenance and Inspection
Describes the daily and periodic inspections, including inspection methods and
replacement of batteries and other parts.
Appendix A: Base unit BUM7B
Describes the specification and usage of BUM7B and registration of tools.
Appendix B: Terminal block signal conversion adapter
Describes the part name and wiring specification of the terminal block signal
conversion adapter.
Also refer to the following manuals:
• Unified controller nv series type1 light Controller Unit User's Manual - Basic Hardware -
• Unified controller nv series type1 light Controller Unit User's Manual -Function-
• Unified controller nv series /V series Engineering Tool4 -Set Up-
• Unified controller nv series/V series Engineering Tool4 -BASIC-
• Unified controller nv series/V series Programming Instructions (LD/FBD/SFC/ST)
• Unified controller nv series type1 light T series Migration Guide (new)
• G2 I/O Adapter (GA922) Module Instruction Manual
1
・ G3I/O アダプタ(GA932 ※ )モジュール 取扱説明書
Unified Controller nv Series type1 light Controller Unit Operating Instructions
6F8C1497
6F8C1498
6F8C1291
6F8C1290
6F8C1226
6F8C1497
6F8C1516
6E8C5606
xiii