Toshiba NV Series Hardware Manual page 144

The association between the mounting holes for the top bracket of base unit BUM7B
dedicated to the migration system and those for G2 I/O module is shown below.
Insert a 150mm or longer Phillips screwdriver into the G2 I/O module mounting hole on
the top bracket to tighten or loosen the screw securing the G2 I/O module (tightening
torque: 1.47N･m).
G2 I/O module mounting hole x 7
S2, S3, S5, S6, S7, S9, S10
Top bracket front view
Top bracket mounting hole x 4
Top bracket mounting plane
Figure A.4 BUM7B's G2 I/O module mounting holes and screwdriver insertion
Insert the screwdriver in S5
[S1] [S2] [S3] [S4]
G2 I/O module mounting hole x 11
Module mounting base panel
Unified Controller nv Series type1 light Controller Unit Operating Instructions
Common to top bracket mounting
G2 I/O module mounting hole x 4
S1, S4, S8, S11
[S5] [S6] [S7] [S8]
A
[S9] [S10] [S11]
125