Remote Control Mode; Tig Comfort Stop Function - Fronius TransPocket 2500 Comfort Operating Instructions Manual

IMPORTANT!
As long as the torch is touching the workpiece, the gas pre-flow takes place auto-
matically.
If the torch and workpiece remain in contact for more than 3 seconds, the welding current
switches off automatically. Place the gas nozzle on the ignition location again.
4.
5.
Placing the gas nozzle down Arc ignites when electrode is
Torch settings when welding begins
Remote control If there is a remote control unit connected to the remote control socket or if the TP09 wire-
mode less remote control unit is used, the symbol „EXT" appears on the display:
All the possible welding parameter settings are made via the remote control unit.
TIG Comfort Stop The "TIG Comfort Stop" function (TCS) is only available with the TP 2500/3500 TIG power
function source. The TIG-Comfort-Stop function is deactivated as standard. Activating and setting
the TIG Comfort Stop function is described in the "The Setup menu" section.
If the TIG Comfort Stop function is deactivated, end crater filling through current decrease
or gas shielding of the end crater does not occur. To finish welding lift the torch away from
the workpiece until the arc goes out.
To finish welding with activated TCS function, proceed as follows:
1.
2.
3.
38
Raise the torch and tilt it into the normal position - the arc now ignites
Carry out welding
Welding
During welding, raise the welding torch
- The arc length is increased significantly
Lower the welding torch
- The arc length is decreased significantly
- This triggers the TIG Comfort Stop function
touched down on workpiece
Raising the gas nozzle, arc ig-
nites