3D Systems Cube User Manual page 7

4. Select Print.
5. Using the arrows, navigate to the file name of your creation. Press Print.
If the print file requires another material is not installed, the printer will prompt
you to change the cartridge(s). Select
Replacing A Material Cartridge
section titled
If there is not enough material in the cartridge to complete the print, the print-
er will prompt you to either change the cartridges or continue using the car-
tridge until the print material has been depleted. To change the cartridge, press
CHANGE CARTRIDGE
Cartridge in the User Guide. Press
terial in the cartridge. You will be prompted to replace the cartridge once the
material has been depleted.
3D Systems, Inc.
CHANGE CARTRIDGE
in the User Guide.
and refer to the section titled
SKIP to continue using the remaining ma-
and refer to the
Replacing A Material
6