3D Systems Cube User Manual page 10

8. Once the printer has finished printing, press accept to continue. The printer jets
will begin to cool down.
!
CAUTION: Do not touch the print jets until they have cooled to room
temperature.
Removing your creation from the print pad
CAUTION: Before attempting to remove your creation from the print pad, ensure that the Cube has finished printing.
!
Once printing has completed, the print platform and print pad will move to the bottom of the
1. Grasp both of the print pad, lift upward and remove it from the print platform.
2. Submerge the print pad and the base of the part in warm water for ten minutes.
NOTE: If the part does not release from the print pad easily, allow the part to soak longer.
NOTE: IF you can not submerge the print pad in warm water, run hot water over the base of the part for ten (10)
minutes. If the part still does not release easily from the print pad after ten (10) minutes, continue to run hot
water over the part.
3. Using a rounded scraper, gently release your creation from the print pad.
! CAUTION: Always move the scraper away from the body. The scraper can
cause injury if not used correctly.
NOTE: The appearance of your scraper may differ from the
illustration.
!
CAUTION: Exercise caution when using a tool to remove a part so the
print pad is not damaged.
4. Rinse your creation under hot water to ensure all of the glue has been removed.
5. Rinse the print pad under water to clean off any remaining glue.
6. Dry the print pad completely before reinstalling it into the printer.
! CAUTION: Failure to completely dry the print pad before reinstalling it into the printer can damage sensitive
electrical components and void the manufacturer's warranty.
3D Systems, Inc. 9
printer.