Raven SmarTrax Installation Manual page 29

FIGURE 8. Grommet in Bottom of Compartment
4. Remove the rubber grommet in the bottom of the compartment.
FIGURE 9. Node Harness Routed to Machine's Bulkhead
5. Route the 21-pin bulkhead connector on the node harness into the hole in the bottom of the compartment.
FIGURE 10. Node Harness Secured to Bulkhead
6. From outside the cab, secure the bulkhead connector to the machine using the lock nut on the connector.
Manual No. 016-5031-006 Rev. B
CAB COMPONENT INSTALLATION
25