Switching The Server On And Off - Fujitsu PRIMERGY TX150 S5 Operating Manual

Starting Up and Operation
5.3

Switching the Server On and Off

V
CAUTION!
It nothing appears on the screen but flickering stripes after switching on
the server, switch the server off immediately (see chapter
shooting and Tips" on page
The power button does not disconnect the server from the mains voltage.
To disconnect from the mains completely, remove the power plug.
Switching the server on
The power on indicator (item 2 in Figure
(Standby mode) when the server is connected to the mains.
– Starting up for the first time:
Ê Press the On/Off button (item 1 in Figure
The power on indicator lights up green (item 2 in Figure
Ê Insert the ServerStart CD and/or an installation disk in the corresponding
drive.
Ê Follow the on-screen instructions (see also section
ServerStart" on page 73
page 74).
– System already installed:
The power on indicator lights up orange (item 2 in Figure
Ê Press the On/Off button (item 1 in Figure
The server is switched on, performs a system test and boots the
operating system.
TX150 S5
Switching the Server On and Off
79).
24 on page
or "Configuration without ServerStart" on
Operating Manual
"Trouble-
63) lights up orange
24 on page 63).
24 on page
"Configuration with
24 on page
24 on page 63).
63).
63).
71