Table of Contents
Advertisement
Hardware Installation
4.4.3
Installation in 3rd Party Racks
The following parts are required to install the server in 3rd party racks:
– Support bracket
– Two variable rails and two telescopic rails
– Possibly protective hose for fiber channel fiber optic cable
Ê Refer to the original manual from the rack manufacturer for details of the
mechanical installation and the climatic conditions.
V
CAUTION!
For installation in 3rd party racks, it must be ensured that an air flow
from the front to the back of the rack is guaranteed.
Ê Fit the required original parts (support bracket or cable management
system).
I
Under certain circumstances, you will not be able to use some of the
parts from the rack installation kit supplied - you will need to use
original 3rd party rack parts instead.
Ê Fit the prepared rails in the 3rd party rack, as described in section
lation in PRIMECENTER/DataCenter Rack" on page
Ê Insert the server (see section
Ê Route the cables as described in the original rack manual.
TX150 S5
Installing/Removing the Rack Model
"Inserting the server" on page
Operating Manual
"Instal-
42.
54).
53
Advertisement
Table of Contents
