Position The Air Conditioner Cabinet - Whirlpool Air Conditioner Use & Care Manual

ii::%;_i_'_ ', i i ! _ bii'_'_J_ 'ii%_@, ,_iiii_, hi iii'¸ C:o 1% d ii_i_'kii::i,_,z ¸¸!i_i_ e _ C:_0_iib ii _ h e i: ¸
• Handle air conditioner with care.
• Be sure your air conditioner cabinet does not fall out of the
opening during installation or removal.
• The place where the power cord exits the air conditioner
should be no more than 4 ft (122 cm) from a grounded 3
prong outlet.
• Do not block the louvers on the front panel.
• Do not block the louvers on the outside of the air conditioner.
Window installation (on some models)
1. Center empty cabinet in window. Check that lower rail of air
conditioner cabinet is behind and against back side of
windowsill. Maintain a firm hold on the air conditioner
cabinet. Lower window sash to hold cabinet in place.
2. Measure the distance between the right-hand side of the
cabinet and the inside of the window channel.
3. Repeat for the left side. Adjust the cabinet until the distance
on each side is the same.
Top View
6.
..... C
A. Left-hand curtain
B. Window channel
C. #8 x ¾" round-head screw
Insert one of the #8 x 3/4"round-head screws through
hole and into lower window sash. Insert one of the
#6 - 32 x 1/4"pan-head screws through threaded hole in top
of curtain.
A B C
A. Window sash
B. Empty cabinet
C. Window channel
4. Check that air conditioner cabinet is tilted to the outside so
that water will run to the outside.
5. Pull left-hand curtain out until it fits into window channel. Use
a 3/=,, drill bit to drill a starter hole through the hole in the
curtain housing and into the lower window sash.
Front View
B ......
A. Left-hand curtain
B. Window channel
A. Hole for #8 x _" round-head screw
B. Threaded hole
C. #6 - 32 x _" pan-head screw
7. Repeat for right-hand curtain.
8. Insert foam seal behind the top of the lower window sash and
against the glass of the upper window.
9. Place window-lock bracket on top of lower window and
against upper window sash.
10. Use a ¾2" drill bit to drill a starter hole through the hole in the
bracket and into the window sash.
11. Attach window-lock bracket to window sash with
#8 x 3/4" round-head screw to secure window in place.
A. Window lock bracket
B. Foam seal
C. Upper window glass