Exerpeutic Momentum Bike Owner's Manual page 14

ASSEMBLY
TOOL:
6mm Allen Wrench with
Phillips Screwdriver
1PC
STEP 4
4a. Hardware Removal: Remove four Hex Bolt (42), four Spring Washers (52) and four Flat
Washers (14) from the Handlebar Post (5)
4b. Installing the Front Post to the Main Frame: Loosen the Spring Knob (25) by turning it
Counter-Clockwise then pull Spring Knob (25) out, insert the Handlebar Post (5) into the Main
Frame (1), release the Spring Knob (25), Press down on the Handlebar Post (5) until it "Pops"
into one of the adjustment holes and tighten the Spring Knob (25) Clockwise.
TIP : When adjusting the height of Front Post (5), the STOP line cannot be higher than
the edge of the plastic bushing.
4c. Installing the Handlebars to the Front Post: Attach the Handlebar (7) onto the Front Post
(5). Secure the Handlebar (7) with four Hex Bolt (42), four Spring Washers (52) and four Flat
Washers (14) that were previous removed then fully tighten with the 6mm Allen Wrench with
Phillips Screwdriver provided.
Pre-Installed Hardware:
(14) Flat Washer (52) Spring Washer
(42) Hex Bolt
4PCS 4PCS
4PCS
12