Exerpeutic Momentum Bike Owner's Manual page 13

ASSEMBLY
TOOL:
13-15mm Wrench
1PC
STEP 3
3a. Remove the Seat Post (4) from the Main Frame (1) by turning the Spring Knob (77) Counter-
clockwise and pulling the Seat Post (4) up.
See Fig. A
3b. Seat Post & Seat Installation: Pull the Spring Knob (77) out, insert the Seat Post (4) into the
Main Frame (1), release the Spring Knob (77), Press down on the Seat Post (4) until it "Pops"
into one of the adjustment holes and tighten the Spring Knob (77) Clockwise.
Attach the Seat (45) onto the Seat Bracket (6) by using 13-15mm Wrench provided. See Fig. B.
TIP : When adjusting the height of Seat Post (4), the STOP line cannot be higher than
the edge of the plastic bushing.
11