How To Run A Local Wash Formula With Liquor Ratio Control; Figure 9 Load Weight Window - Milnor MilTouch Operator's Manual

Run and Monitor Formulas
4.1.1.1.2

How to Run a Local Wash Formula with Liquor Ratio Control

Use the following instructions to run a wash formula if your machine is configured to use Liquor
Ratio Control, but not equipped with the optional weighing system.
1. On the Home display, select the formula that your chemical supplier or laundry specialist set
to use Liquor Ratio Control.
2. Touch . The Load Weight window appears (shown in the following figure).
Figure 9. Load Weight Window
3. Enter the customer code.
a. Touch the value labelled "Customer."
b. Use the keypad to enter a customer code number.
4. Enter the actual weight of the goods in each compartment. A machine can have up to 3
compartments.
a. Touch the value labelled "Weight 1."
b. Use the keypad to enter the actual weight of the goods in Compartment 1, or the total
weight of goods if you have an open-pocket (one compartment) machine.
NOTE: Ensure that you measure and enter the actual weight of goods in the
same unit (pounds or kilograms) as the configured machine capacity.
c. If your machine has more than one compartment, touch the values labelled "Weight 2"
and "Weight 3" to enter the actual weight of the goods in Compartment 2 and Compart-
ment 3, respectively.
5. Touch to save all the data entered in the window and start the formula.
20
BNCLKO02.T02 0000252005 B.2 B.3 C.6 3/12/20 11:44 AM Released
A...
used to wash the goods
B...
laundry) or department (insti-
tutional laundry) the batch
(goods) belongs to.
C...
machine, divided into com-
partments. Weight 2 and
Weight 3 are only used on
divided-cylinder machines.
D... Start the formula
E... Close the window and return
to the Home display
Legend
The formula that will be
The customer (commercial
The weight of goods in the
Pellerin Milnor Corporation