Modify Step Timer; Figure 17 Manual Control Areas; Figure 18 Pop-Up Controls For Step Timer - Milnor MilTouch Operator's Manual

When you touch
the Run display, controls
in the Names and Timers
area and the Machine Sta-
tus area of the Run dis-
play become active so that
you can manually change
the formula in progress.
Green boxes on the dis-
play identify the manual
control areas, or the set-
tings that can be changed,
as shown in Figure 17
In manual mode, touch a
box to display the pop-up
controls for that setting.
You can adjust the:
• step timer
• water valves
• drain and reuse valves
• steam and cooldown
controls
• cylinder speed
• bath temperature and
level
The pop-up controls available correspond with your machine's equipment and your configuration
decisions.
Touch to resume automatic operation.
NOTICE: The MilTouch™ controller prevents the activation of a manual control when
its activation would be inappropriate. For example, the controls for the water valves are
not available when the bath water is at its maximum level.

Modify Step Timer

Figure 18. Pop-up Controls for Step Timer
Add 1 minute to the remaining step time.
Pellerin Milnor Corporation
Figure 17. Manual Control Areas
on
.
C. Cylinder speed controls
D. Drain and reuse controls
Lw. Bath level controls
R. Return to Run mode
Steam and cooldown controls
S.
St. Step timer controls
T. Terminate (cancel) formula
Tw. Bath temperature controls
W. Water valve controls
— Touch the box identified by item St on
Troubleshooting
Legend
Figure 17 .
27