Putty Settings For Vplex_Service Session - EMC VPLEX with GeoSynchrony 4.2 Installation And Setup Manual

Hide thumbs

Table Of Contents

Table of Contents

Setting up a VPLEX Metro implementation

Figure 29

EMC VPLEX with GeoSynchrony 4.2 Installation and Setup Guide

b. Select Use the following IP addresses, and type the following values:

– IP address:

– Subnet mask:

– Default gateway: 128.221.252.2

7. Click OK on the Internet Protocol (TCP/IP) Properties window, and again on the

Local Area Connection Properties window.

8. Close the Network Connections window.

9. Open a Command Prompt window (Start > Programs > Accessories > Command

Prompt), and type the following command to confirm the settings:

ipconfig

Output example:

Ethernet adapter Local Area Connection:

Connection-specific DNS Suffix

IP Address. . . . . . . . . . . . : 128.221.252.3

Subnet Mask . . . . . . . . . . . : 255.255.255.224

Default Gateway . . . . . . . . . : 128.221.252.2

10. Type the following command to verify that you can reach the management

server's service port:

ping 128.221.252.2

11. On your laptop, launch PuTTY.exe.

If you see a PuTTY security alert, read it, and then click yes.

Note: The tasks in this document use PuTTY for logging in to the management server.

However, you can use any similar Telnet/SSH client.

12. Configure the PuTTY Configuration window as shown in