Outdoor Use Only - Fire Sense 1337 Instructions And Parts Manual

NOTE: PLEASE READ THE FOLLOWING SAFETY RULES
WARNING:
This heater must only be used outdoors. Using this product in an enclosed
area may cause injury, death or property damage.
Only use in a well-ventilated space. Do not use in a building, garage, or any
other enclosed area.
Read the instructions before use. This heater must be installed in
accordance
with local codes or, in the absences of local codes, with the National Fuel
Code, ANSI Z223.1. If applicable, the appliance, when installed, must be
electrically grounded in accordance with local codes or, in the absence of
local codes, with The National Electrical Code, ANSI/NFPA70.
Do not use the heater in an explosive atmosphere. Keep the heater away
from areas where gasoline or other flammable liquids or vapors are stored.
Prior to use, check for damaged parts such as hoses, regulators, pilot or
burner.
Turn off and disconnect LPG cylinder before moving the heater.
Do not attempt to alter this heater in any manner. EXAMPLE: Using the
heater without the mesh guard or radiant screen.
Do not use the heater in basements or below ground level. It must always
be placed on a solid and level surface.
Always ensure there is ample fresh air ventilation. This heater if for

OUTDOOR use ONLY.

Never replace or substitute the regulator with any regulator other than the
factory suggested replacement.
Do not clean the heater with cleaners that are combustible or corrosive.
Do not paint radiant screen, control panel or mesh guard.
All leak tests should be done with a soapy solution. NEVER USE AN OPEN
FLAME TO CHECK FOR LEAKS.
The LPG cylinder should be turned off when the heater is not in use.
At least once a year, the heater should be inspected for the presence of
spiders, spider webs or other insects.
-
PRECAUTIONS
3 -