To Load The Hp 16505A Prototype Analyzer Files - HP E2466C User Manual

Setting Up the Preprocessor Interface Software

To load the HP 16505A Prototype Analyzer files

To load the HP 16505A Prototype Analyzer files
The HP 16505A Prototype Analyzer is required for transaction
tracking and inverse assembly. To set up the prototype analyzer:
If you have not already done so, copy the logic analyzer files as
1
described in the previous section.
The HP 16500B/C files must be copied to the logic analyzer hard drive first
for the HP 16505A to access them.
Connect the HP 16505A to the HP 16500B/C. Power up the
2
HP 16500B/C first, then power up the HP 16505A.
For information on connecting the HP 16505A, refer to the HP 16505A
Installation Guide.
Ensure that the HP 16505A has software version A.01.30 or greater.
3
You may check the HP 16505A system version from a running session. In the
Main window, click Help, then click "On Version...".
Install the HP 16505A software for the Pentium II processor.
4
Place the "HP 16505A Prototype Analyzer Disk" flexible disk in the disk drive
of the HP 16505A. In the Session Manager window, select the Update
button. The window should display
Filegroup: pp_pentium2
Version: A.01.30.
Click on Update/Install and respond to the question by clicking on OK. Wait
for the Information dialog to confirm a successful installation. Click on OK to
acknowledge, and Close the Update/Install window.
Load the logic analyzer configuration file.
5
Start a session from the Session Manager window. When the main
HP 16505A window opens, click on File in the top menu bar to get a
pull-down menu, then click on "Load 16500 Files...". Change to the
appropriate directory and load the appropriate file, either CP6C_1P or
CP6C_2P (for Pentium II processor only analysis) or CP6C_1AP or
CP6C_2AP (for Pentium II processor and HP E2467A APIC Bus analysis).
Next, drag and drop the "Pentium II" Instrument icon into the workspace
area. Next, drag and drop a Listing Display on the "Pentium II" Instrument
icon in the workspace. Double click on the Listing icon to open the Listing
window and verify that the label "Pentium II Inverse Assembly" appears.
1-18 Preprocessor Interface for the Pentium II Processor