HP E2466C User Manual page 17

Setting Up the Preprocessor Interface Hardware
To disassemble the S.E.C. cartridge
Using the instructions in the Intel S.E.C. Cartridge Disassembly
2
Application Note, insert a 1/8" small flat blade screwdriver between
the cover and the thermal plate, next to one of the four barbed posts
located at each corner of the thermal plate. Twist the screwdriver
until the barbed post pops free. Repeat this procedure for the other
barbed post at the same end of the cartridge, then repeat for the
other end of the cartridge.
Figure 4
Disassembling the S.E.C. Cartridge
Using the instructions in the Intel S.E.C. Cartridge Disassembly
3
Application Note, use fine-tip round nose pliers to separate the tabs
on the thermal plate away from the locator pins. Remove the spring
retainer clips, then separate the thermal plate from the
microprocessor circuit board.
1-8 Preprocessor Interface for the Pentium II Processor