Before You Begin - HP E2466C User Manual

Before You Begin

This section lists the logic analyzers supported by the HP E2466C, and
provides other information about the analyzers and the preprocessor.
Equipment Supplied
•
The preprocessor interface circuit board.
•
Cable, interposer, bottom clamp, and heat sink.
•
The configuration files, for the logic analyzer and HP 16500B/C mainframe,
on a 3.5-inch disk. There are also Demo files for all supported logic
analyzers on the disk.
•
Transaction tracker/inverse assembly software for the HP 16505A
Prototype Analyzer on a 3.5-inch disk.
•
This User's Guide.
Minimum Equipment Required
•
The HP E2466C Preprocessor Interface, configuration files, and
transaction tracker software.
•
An HP 16505A Prototype Analyzer.
•
A target system with the microprocessor circuit board removed from the
S.E.C. cartridge. Detailed instructions for disassembling the S.E.C.
cartridge can be found in Intel's S.E.C. Cartridge Disassembly
Application Note.
•
One of the logic analyzers listed in the table on page ii, in an HP 16500B/C
Logic Analysis Mainframe.
For instruction disassembly, Branch Trace Messages must be enabled and
instruction caches must be disabled. This requires a Pentium II processor
run-control tool such as the HP E3493A, and a 30-pin debug port on the target
system. The HP E3493A run-control tool requires firmware version v2.15 or
higher for the Pentium II processor.
Preprocessor Interface for the Pentium II Processor 1-3