Signal-To-Connector Mapping - HP E2466C User Manual

Signal-to-Connector Mapping

The following table describes the electrical interconnections implemented
with the HP E2466C Preprocessor Interface. Since the pods on the
logic analyzers are numbered differently than the preprocessor connectors,
refer to the tables in chapter 1 to correlate the pod numbers.
The signal list table column descriptions are as follows:
PREPROCESSOR NAME
CONNECTOR PIN
BIT
CPU SIGNAL
ANALYZER LABEL(S)
Preprocessor Interface for the Pentium II Processor
Preprocessor Interface Hardware Reference
The preprocessor connector that carries the signal.
The pin within the preprocessor connector that carries the signal.
The bit position of the signal within the preprocessor connector.
The microprocessor signal name.
The analyzer label assigned to the signal. Lower case letters
indicate a preprocessor generated signal.
Signal-to-Connector Mapping
3-9