Using The Analyzer; Source Line Referencing; Specifying A Simple Trigger - HP 7750 Series User Manual

Note
Note
Note

Using the Analyzer

Source Line
Referencing
Specifying a Simple
Trigger
Step command is not available when the emulator is used with a
foreground monitor.
Step command to internal RAM area is not allowed.
When the emulator performs single step execution, all memory access
is performed by byte access.
HP 64700 emulators contain an emulation analyzer. The emulation
analyzer monitors the internal emulation lines (address, data, and
status). Optionally, you may have an additional 16 trace signals which
monitor external input lines. The analyzer collects data at each pulse of
a clock signal, and saves the data (a trace state) if it meets a "storage
qualification" condition.
A trace may be taken and displayed using source line referencing.
Also, lines of the source program can be displayed with the trace list
where the trace occurred.
To display the trace with source code in inverse video, enter the
following command:
set source on inverse_video on <RETURN>
Suppose you want you trace program execution after the point at
address semantic_check. The following command make this trace
Getting Started 2-27