Door Surround Assembly
T
Figure 9
To install the completed left door sur-
round assembly to the vehicle, use two
medium stem door Surround Knobs (T)
to fasten both Door Surround Brackets
to the sport bar. (See FIG 9) Repeat this
procedure for the Right Side.
S
2 Door Adventure Top
Figure 11
Make sure door surround brackets are
not interfering with roll bar padding.
(see FIG 11)
T
Install both left and right completed
door surround assemblies using the
appropriate knobs listed in (FIG 9).
Firstly insert the Upright Lower Plastic's
alignment pin into the body tub rail hole
and slide the door surround assembly
onto the sport bars and align the holes
on the front and rear Door Surround
Brackets. (See FIG 10)
Installation:
Make sure rubber gaskets are seated
properly as shown. (see FIG 12)
The Trusted Source
7
®
Figure 10
Figure 12