Table of Contents
Advertisement
Operate
6.1 Operation overview
Figure 6-4
1. Once you activate the parameter, you will still remain in read mode. You are not able to
2. To select this option, press
3. To select additional options, press
4. To exit the parameter and apply the value, press
Parameters which involve setting values
1. Use
2. To change the digit, press
3. To exit the parameter and apply the value, press
Example: Set value for start position in partial stroke test to 1.0
Navigate to menu "3.5.2.1
Start position" (Page 99).
Cancel entry: press
Back to measurement view
To reach the measurement view again, press
appears in the display.
60
Procedure
select an option. Press
highlighted in black.
backfilled in black.
or
to select the relevant item whose value you want to change. By default, the
most recently set value is always shown. Each item can be individually adjusted.
Go to the first 0 by pressing
twice. 0 is now
highlighted in black.
until you exit the view.
. You are now in editing mode. The currently selected option is
again. The quadrant at the left of the option is now
or
.
or
. The digits 0 to 9 can be set.
To change the value
of the digit to 1,
press
.
repeatedly until the measurement view
.
until the view changes.
To adopt the value: Press
last 0 is highlighted in black. Now press
once more. The value has been
adopted.
SITRANS VP300 with or without HART
Operating Instructions, 03/2011, A5E01258666-03
until the
Advertisement
Table of Contents
