Table of Contents
Advertisement
Commissioning
7.5 Autom. initialization
7.5
Autom. initialization
Requirement
You have prepared the positioner for commissioning, as described in section "Preparing for
commissioning (Page 132)".
Procedure
In order to initialize the positioner automatically, proceed as follow:
1. To change from the measurement view into the navigation view, press
2. Click
3. Select the actuator type with
4. Confirm the selection with
5. If required, set the tight closing function.
136
"1 Quick Start" main menu.
four times. The display shows the following:
The factory setting is "Linear <= 60 mm".
Use
or
to switch to the menu "1 Quick Start > 1.1 Autom. initialization > 1.1.2 Tight
closing > Edit".
or
. The set actuator type is displayed.
Operating Instructions, 03/2011, A5E01258666-03
. You are in the
SITRANS VP300 with or without HART
Advertisement
Table of Contents
