Table of Contents
Advertisement
Commissioning
7.6 Manual initialization
7.6
Manual initialization
Requirement
You have prepared the positioner for commissioning, as described in section "Preparing for
commissioning (Page 132)".
Procedure
In order to initialize the positioner manually, proceed as follow:
1. To change from the measurement view into the navigation view, click
2. Use
3. Select the actuator type with
4. Confirm the selection with
5. If required, set the tight closing function. Use
6. Select the tight closing function with
7. Confirm the selection with
138
"1 Quick Start" main menu.
and
to switch to the menu "1.2 Manual initialization > 1.2.1 Actuator type >
Edit".
The factory setting is "Linear <= 60 mm (2.36")".
closing > Edit".
Factory setting is "Off".
or
. The set actuator type is displayed.
and
and
.
Operating Instructions, 03/2011, A5E01258666-03
. You are in the
to switch to the menu "1.2.2 Tight
SITRANS VP300 with or without HART
Advertisement
Table of Contents
