Connection And Wiring Of A Vision Sensor - Mitsubishi Electric VS20M-11F310 Connection Manual

Connection and wiring of a vision sensor

This section shows the procedure for connecting and wiring a vision sensor.
Ethernet cable connection
1.
Connect the Ethernet cable's M12 connector to the vision sensor's Ethernet connector.
2.
Connect the Ethernet cable's RJ-45 connector to the switching hub or personal computer, as applicable.
Connecting an I/O module (CIO-1400 I/O extension module) and an input/output module
1.
Check that the 24 VDC power supply is OFF.
2.
Connect a CIO-1400 I/O extension module and an input/output module as shown in the following figure.
24 VDC
power supply
Precautions
• Use only 24 VDC and observe the indicated polarity.
• When connecting a vision sensor and a programmable controller, simultaneously turn ON the power of the vision sensor
and programmable controller, or first turn ON the power of the programmable controller.
• Cut unused wires or protect them with insulating materials. Be careful not to short-circuit with 24 VDC wires.
• The cable is designed to connect with its key aligned with the keyway of the connector on the Vision Sensor. Do not force
the connections or damage may occur.
For details on the connection with a vision sensor, refer to the user's manual of the vision sensor used.
3 I/O CONNECTION
68
3.1 System Configuration Example for Connecting a Vision Sensor
24 VDC
GND
Trigger
24 VDC
General-purpose input 1
Input common
General-purpose output 3
General-purpose output 2
High-speed output 1
High-speed output 0
Output common