Outputting to the programmable controller
1.
Set data to be output from the vision sensor to the programmable controller.
As an example, set PASS, FAIL, and the number of inspection to the output word block (D1015 to D1017).
Ó
2.
Select the data to be output to the programmable controller.
Ó
Ò
3.
The output result to the programmable controller is displayed.
Ò
Ô
Device Address: D1015 to D1017
Message size (words): 3
Items corresponding to the device address can be changed by using the [Up] and [Down] button. As an example, sort as above.
• D01015: Pattern_1.Pass
• D01016: Pattern_1.Fail
• D01017: Job.Inspection_Count
Ò
Ô
Select the [Format Output Data]
tab.
Click the [Add] button.
Select "Pattern_1 inspection result
(PASS/FAIL)".
Select "Job.Inspection_Count".
Click the [OK] button.
2 SLMP SCANNER CONNECTION
2.3 Setting the Vision Sensor
2
Ó
47