Changing Jobs (Loading Another Job) - Mitsubishi Electric VS20M-11F310 Connection Manual

Changing jobs (loading another job)

The following shows the procedure to load the job file "1Test".
The number '1' prefixed to the file name indicates an ID. By setting this ID number to 'Command' (D2000) of an input word
block, the job ("1Test") can be loaded.
Set a device value in the "Device/Buffer Memory Batch Monitor" window in GX Works3.
1.
Set an ID number of a job.
Ò
2.
Change jobs (load another job).
Ò
Õ
To load a job, the file name of the job need to begin with an ID number.
When loading a job, make a vision sensor offline.
2 SLMP SCANNER CONNECTION
62
2.6 Checking Operations
Ô
Ô
Ó
 Enter 'D2000' for "Device Name".
 Click the [Start Monitoring] button.
 Enter '1' for 'Command' (D2000) of
Ó
an input word block.
 Enter 'D1000' for "Device Name".
 Turn ON 'Set Offline' (D1000.7) of a
control bit block to make the vision
sensor offline.
 Turn ON 'Execute Command'
(D1000.4) of a control bit block to load
a job.
 When the loading of the job is
completed, 'Command Completed'
(D1002.D) of a status bit block is
changed (toggled). After that, turn OFF
'Execute Command' (D1000.4) and
'Set Offline' (D1000.7).