Mitsubishi Electric VS20M-11F310 Connection Manual page 55

4.
Set an Ethernet configuration.
Ò
In another way to set an Ethernet configuration, set a target device from Module List.
In that case, set TCP for Protocol.
5.
Apply the setting.
Ó
 Click the [Detect Now] button.
• Read the message and click the
[Yes] button.
• Check that the connected vision
sensor is displayed.
 Click [Close with Reflecting the
Setting].
For details on the automatic detection
function of connected devices, refer to
the following manual.
iQ Sensor Solution Reference
Manual
 Click the [Apply] button to end the
settings.
Ò
2 SLMP SCANNER CONNECTION
2.4 Setting a Programmable Controller
2
53