Setup; Indication Of The Switching Status; Function Test - Vega VEGASWING 51 Operating Instructions Manual

VEGASWING 51 - - contactless electronic switch

6 Setup

6.1 Indication of the switching status

The switching status of the electronics can be checked on the
upper part of the housing.

6.2 Function test

VEGASWING 51 has an integrated test switch which can be
activated magnetically. Proceed as follows to test the instru-
ment:
à
Hold the test magnet (accessory) to the magnet symbol on
the instrument housing
Fig. 11: Function test
The test magnet changes the current switching condition of the
instrument. You can check the change on the signal lamp.
Please note that the connected instruments are activated
during the test.
If VEGASWING 51 does not switch over after several tests
with the test magnet, you have to check the plug connection
and the connection cable and test the instrument again. If there
is no switching function, the electronics will be defective. In this
case you have to exchange the electronics or return the
instrument to our repair department.
Setup
21