Vega VEGASWING 51 Operating Instructions Manual page 14

Mounting
Adhesive products
Inflowing medium
14
Fig. 5: Marking on the welded socket
1 Marking
In case of horizontal mounting in adhesive and viscous
products, the surfaces of the tuning fork should be vertical in
order to reduce buildup on the tuning fork. The position of the
tuning fork is indicated by a marking on the hexagon of
VEGASWING 51. With this, you can check the position of the
tuning fork when screwing it in. When the hexagon touches the
seal, the thread can still be turned by approx. half a turn. This
is sufficient to reach the recommended installation position.
In adhesive and viscous products, the surfaces of the tuning
fork should protrude into the vessel to avoid buildup. Therefore
sockets for flanges and mountings bosses should not exceed
a certain length.
Fig. 6: Adhesive products
If VEGASWING 51 is mounted in the filling stream, unwanted
false measurements may be generated. Mount VEGASWING
51 at a location in the vessel where no disturbing influence
from e.g. filling openings, agitators, etc. can occur.
VEGASWING 51 - - contactless electronic switch
1
30mm
(1 3 / ")
16