Intended Use; Control; Pushbutton - Webasto ThermoConnect TCon2 Operating And Installation Instructions

DANGER
EN
Risk of injury from the defective
unit
Do not operate a defective Thermo-
Connect TCon2 and put it out of ser-
vice by removing the fuse:
prolonged heavy smoke develop-
u
ment
unusual burner noise
u
Smell of fuel
u
permanent fault shutdowns with er-
u
ror messages (blink code)
Damaged heater
u
ð Contact a Webasto service
workshop.
4

Intended use

The control element ThermoConnect
TCon2 is currently approved for the follow-
ing applications:
Switching Webasto air and water heaters
on and off.
The ThermoConnect TCon2 has an integ-
rated GPS antenna and an eSIM (embed-
ded SIM).
5

Control

You can operate the air - or water heater in
3 ways:
– With the provided button.
4
– With the ThermoConnect app on a mo-
bile phone.
– With the "My WebastoConnect" web
page.
6

Pushbutton

Fig. 1
The pushbutton must be located within the
driver's field of view and operation. Install
the pushbutton at an accessible location, a
protected area. The pushbutton switches
the air- or water heater on or off with a de-
fault duration (60 minutes).
u Press the pushbutton to start the air- or
water heater.
If necessary, the default duration can be
changed. See chapter 8 "My WebastoCon-
nect web service" on page 5.
The illumination of the pushbutton is also a
status indicator:
– LED does not light up - The heater is
switched off
– LED is blinking green - The ThermoCon-
nect TCon2 is not connected, is search-
ing for a network or is restarting
– LED lights up green - Heater is on
Use of the pushbutton to restart and reset
the ThermoConnect TCon2 receiver.
– Restart see chapter 6.1 "Restart" on
page 4.
– Reset see chapter 6.2 "Settings reset"
on page 4.
6.1 Restart
WHE000015A
u Press and hold the pushbutton for 10 s.
u
Release the pushbutton.
– The ThermoConnect TCon2 restarts.
– The illumination of the pushbutton
blinks while the ThermoConnect TCon2
restarts.
6.2 Settings reset
NOTE
Settings reset performs the following
functions:
Connection settings revert back to de-
fault.
Removes paired mobile users and user
phone numbers.
Removes all timers and location-based
events.
Procedure for resetting to factory settings:
u
Press and hold the pushbutton for 10 s.
9040092A