Webasto ThermoConnect TCon2 Operating And Installation Instructions page 7

– The ThermoConnect TCon2 must be in-
stalled inside the car, in a dry and pro-
tected place.
– Installation below dashboard, as high as
possible, on driver side is recommen-
ded.
u
Mark the location of the ThermoCon-
nect TCon2 in the drawing in Fig. 4 4
10.5 Installation of the
3
pushbutton
2
1
2
Fig. 5
Pushbutton Wiring harness
NOTE
Do not disconnect the connector from
the cable.
NOTE
The pushbutton must be installed.
9040092A
NOTE
The pushbutton includes a temperat-
ure sensor. Make sure that the air can
flow around the pushbutton at the in-
stallation location, but the pushbutton
1
must be shielded from direct air flow
from ventilation ducts.
The pushbutton has four functions:
1. Switch the heater on/off.
2. Acknowledge new users.
3. Measure the temperature.
4. Reset or restart, see chapter 6.1 "Re-
start" on page 4/chapter 6.2 "Settings
reset" on page 4.
u Plug on the ThermoConnect TCon2 wir-
ing harness.
u Install the pushbutton at an accessible
WHE000045A
location, a protected area.
– Make sure the illumination is visible dur-
ing operation.
10.6 Wiring harness installation
1
3
2
Fig. 6
ThermoConnect TCon2
Main connector
Heater connector
Pushbutton connection
NOTE
Only install the ThermoConnect TCon2
with the ThermoConnect TCon2 wiring
harness.
10.7 Compatibility with other
Webasto control elements
The ThermoConnect TCon2 can be coupled
in the W-bus network with most Webasto
control elements and always outputs the
EN
4
WHE000030A
7