21
INDEPENDENT/LINKED OPERATION OF
INTERFACE
This chapter explains the independent/linked operation of C24.
21.1
Setting and Data Flow of Independent Operation
Setting
For the independent operation of two interfaces on C24, configure the parameter setting as shown below.
Setting item
Basic
Various control
settings
specification
Data flow in independent operation
Two interfaces operate independently according to the settings in the parameter settings "Basic Settings".
C24 (data flow in independent operation)
CH1
CH2
Test mode setting
Communication protocol setting
Communication speed setting
Transmission setting
Operation setting
Data bit
Parity bit
Odd/even parity
Stop bit
Sum check code
Online change
Setting change
Station number setting (CH1, 2 in common: 0 to 31)
Transmits only
to a designated
CH side.
Setting content
CH1
Set according to the target
device.
Independent
Set according to the target
device.
Set arbitrary value for data communication using the MC
protocol or for multidrop connection when MELSOFT
connection is selected.
CH1
CH2
21 INDEPENDENT/LINKED OPERATION OF INTERFACE
21.1 Setting and Data Flow of Independent Operation
CH2
21
Set according to the target
device.
Independent
Set according to the target
device.
397