Table of Contents
Advertisement
12.4
Modbus Map
Via the link „Add new Modbus Register", new registers / variables can be created.
Register Number:
Assigned to:
Serial Number:
Transmitter Port:
Measurand and Unit:
Failsafe Value:
Data Type:
Factor:
Offset:
Create Register:
Erase of applied registers:
Using "Edit", the configuration of each register can be changed. (in the list „Modbus Register Map")
Via the button „Delete Register" the selected register will be deleted.
Is incremented automatically, but can be changed any time.
Here you select whether a sensor or a transmitter will be mapped to the register.
(For details see 12.3. Outputs -> Mapping the selected measurement signal)
Type in the serial number of the probe or transmitter.
(can be copied from the transmitter list (see section 12.2))
Type in transmitter port (see section 12.2.2)
Adjust desired measurement (T, RH ,..).
Output value, which should be issued for a (transmission) error/alarm.
Select data type (Float, Integer,..)
Possible multiplication factor for the register value (Reg.Value = Current Value * Factor)
Possible offset for the register value (Reg.Value = Current Value * Factor + Offset)
The register will be created with the selcted configuration.
23
Advertisement
Table of Contents
