Table of Contents
Advertisement
12.2.2 Probe Status
If clicked in the 'Transmitter List' on the hyperlink "Name" or "Serial Number", the details of the selected transmitter
will be shown in the bottom part of the screen. Depending on the transmitter model up to three sensing probes can
be connected.
Shows all available data of sensing probe 1:
Status:
Data Age:
TM-Port:
Probe:
Measurand:
Measured Value: Last transmitted measured value.
More transmitter details will be listed as soon as more sensing probes
are connected to the transmitter.
Replacement of a sensing probe:
If a sensing probe has to be replaced (e.g. calibration, etc...), this can be done in a few easy steps:
1) Disconnect the old sensing probe.
2) Connected the new sensing probe.
3) Remove the old sensing probe from the system by clicking "Delete Probe".
12.2.3 Transmitter Status
Battery:
Signal:
Firmware:
Up-Time:
There are three conditions: OK / WARNING / ALERT, see chapter 12.1 Overview.
Indicates the elapsed time since the last transmission of measurement data
Meaning of the Status:
"OK"
- the wireless connection functions w/o failures
"Warn" - the last two data transmissions failed
"Alert" - several data transmissions failed
Indicates to which port the sensing probe is connected (see sketch).
Type of sensing probe and serial number.
Indicates the active measurement parameter of the sensing probe
(temperature, humidity, CO
Indication of the battery power, resp. "Ext. Power" if power supply is external.
Threshold values:
Indication of the wireless signal strength.
Software version of the transmitter.
Elapsed time since the last interruption.
).
2
> 4.6 V
OK
4.3 – 4.6 V
WARNING
< 4.3 V
ALERT => failure of the transmitter
21
Port 1
Port 2
Port 3
Advertisement
Table of Contents
