SKYZER TECHNOLOGIES
5.2 IWL252 BLUETOOTH EFTPOS CONFIGURATION
The EFTPOS Configuration option enables the terminal to be configured to
operate as an EFTPOS terminal and must be done before the terminal can
process transactions.
Step
Terminal Display Comment
1.0
2.0
FUNCTION?
3.0
CONFIG PARAMS?
ENTER OR CLEAR
4.0
TERMINAL ID?
XXXXXXXX
5.0
MERCHANT ID?
XXXXXXXXXXX
6.0
NII?
001
7.0
COMMS MODE?
1-DIAL-UP
8.0
2-TCP-IP / DIAL
9.0
3-TCP-IP
INGENICO IWL25X 2017 PAYMARK SOFTWARE OPERATING GUIDE
Press FUNC
Enter 3824 and press ENTER.
ENTER to configure the parameters or CLEAR to cancel and exit to idle prompt.
This parameter specifies the Terminal ID assigned by Paymark. Key in the 8 digit
terminal ID and press ENTER.
This parameter specifies the Merchant ID assigned by Paymark. Key in the 11 digit
merchant ID and press ENTER.
This parameter specifies the Network International Identifier (by default 001) that
the terminal uses to route messages to Paymark. Press ENTER.
Select the preferred COMMS mode by pressing the corresponding number key. By
default 1-DIAL-UP is always selected.
Press 1 for Dial-up configuration followed by ENTER and proceed with the
configuration.
Press 2 for TCP-IP/Dialup as backup configuration followed by ENTER and
proceed with the configuration.
Press 3 for TCP-IP configuration followed by ENTER and proceed with the
configuration.
PAGE 28 OF 132
Version 1.00