Table of Contents
Advertisement
SKYZER TECHNOLOGIES
6.1.2 SKYLink Interface Com Port
This function allows selecting the com port type to have the interface link
operate on.
Perform the steps below to select the com port type on the ingenico terminal.
Step
Terminal Display Description
1.0
2.0
FUNCTION?
3.0
INTERFACE
COM PORT
1-RS232
2-USB
4.0
RESET INTERFACE
Y/N
NOTE: In the event if the POS system is not communicating with the terminal,
please perform the above steps to reset the interface link and com port.
Repeat the same steps again to set it up with correct settings and save the
changes. After that, restart the terminal by pressing and holding down the
FUNC + CLEAR key for 2 seconds. This will reset the interface link and start
communicating with the POS system.
INGENICO IWL25X 2017 PAYMARK SOFTWARE OPERATING GUIDE
Press FUNC
Enter 6629 and press ENTER
Press the corresponding number key to select the appropriate interface com port
type followed by ENTER key.
1-RS232 (This will be selected if the interface link will be communicating via serial
cable)
2-USB (This will be selected if the interface link will be communicating via USB
cable. Please ensure to load the Telium USB driver to allow the
communication to take place via USB cable)
Press ENTER to reset the interface com port or CLEAR to exit out without resetting
the interface com port.
PAGE 50 OF 132
Version 1.00
Advertisement
Table of Contents
