SKYZER TECHNOLOGIES
7.0
CONFIGURATION
1-Modem Setup
2-Ethernet Setup
3-Battery Setup
4-Cradle Setup
8.0
CRADLE SETUP
1-Association
2-Advanced
3-Base State
9.0
ASSOCIATION
1-New Base
2-Select Base
3-Remove Base
4-Print Bases
10.0
ASSOCIATIONSUCCESSUL
OK
11.0
BASE UPDATE
1-This Base (IR)
2- < Base Name >
12.0
REMOVE BASE
1- <Base Name 1>
2- <Base Name 2>
13.0
INGENICO IWL25X 2017 PAYMARK SOFTWARE OPERATING GUIDE
Press 4 to select CRADLE SETUP
Press 1 to select ASSOCIATION
Pairing Base
Press 1 to select NEW BASE to associate terminal with that base
Unpairing Base
To disassociate terminal from a base, select option 3 – 'REMOVE BASE'. Proceed
with step 12.0
On selecting 'NEW BASE' option, the terminal will immediately perform association
with that base. The terminal will display the outcome of the association attempt.
OK
Press ENTER.
When the terminal is successfully associated with a base, the terminal will prompt
for 'BASE UPDATE' menu. Select option 1; the base that the terminal is newly
associated with to configure the base i.e. Modem configuration.
If 'REMOVE BASE' was selected, the terminal will display the name of the bases it
is associated with. Select the name of the base to disassociate from followed by
ENTER.
Press the CANCEL key unless and until you exit out from the menu and return to
idle screen.
PAGE 25 OF 132
Version 1.00